Suunto Cobra2 User Manual download pdf (Page 40)

8. CARE AND MAINTENANCE

The Suunto Cobra2 dive computer is a sophisticated precision instrument. Though designed

to withstand the rigors of scuba diving, you must handle your Suunto Cobra2 with care,

and follow the advice below on how to maximize its service life.

8.1. Water contacts and buttons

Contamination or dirt on the water contacts/connector or buttons may prevent the automatic

activation of the DIVE mode and cause problems during data transfer. Therefore, it is

important that the water contacts and push buttons are kept clean. If the water contacts

of the instrument are active (AC-text remains on the display) or the DIVE mode activates

on its own, the reason is probably contamination or invisible marine growth that may create

an unwanted electric current between the contacts. It is important that the dive computer

is carefully washed in fresh water after the day's diving is completed. The contacts can

be cleaned with fresh water and, if necessary, a mild detergent and a soft brush.

8.2. Care of your dive computer

•

NEVER try to open the case of the dive computer

•

Have your dive computer serviced every two years or after 200 dives (whichever comes

first) by an authorized Suunto representative. This service will include a general

operational check, replacement of the battery, and a water resistance check. The

service requires special tools and training, so do not attempt to carry out any service

that you are not competent to perform

•

If moisture appears inside the case, have the instrument checked immediately by your

Suunto representative

•

If you detect scratches, cracks or other such flaws on the display that may impair its

durability, have it replaced immediately by your Suunto representative

•

Check the strap and the buckle for flaws. If needed, have them replaced by your Suunto

representative

•

Wash and rinse the unit in fresh water after every use

•

Protect the unit from shock, extreme heat, direct sunlight, and chemical corrosion. The

dive computer cannot withstand the impact of heavy objects like scuba cylinders, nor

chemicals like gasoline, cleaning solvents, aerosol sprays, adhesive agents, paint,

acetone, alcohol etc. Chemical reactions with such agents will damage seals, the case,

and the finish

•

Store your dive computer in a dry place when you are not using it

•

The dive computer displays a battery symbol as a warning when the power gets too

low. When this happens, the instrument should not be used until the battery has been

replaced. Also refer to Section 5.9. Activation and pre-checks

•

Do not fasten the strap of your dive computer too tightly. You should be able to insert

your finger between the strap and your wrist

8.3. Maintenance

If left without care for an extended period, a thin film, often invisible to the naked eye, will

cover the unit. Much like the build-up on the glass of an aquarium, this film is the result of

organic contaminants found in both salt and fresh water. Suntan oil, silicone spray and

grease will speed up this process. As a result of this build-up, moisture will be trapped

next to the water contacts and will prevent your Suunto Cobra2 from operating properly.

The water contacts can be cleaned with a small brush (e.g. toothbrush).

IMPORTANT: Your Suunto Cobra2 should be soaked, then thoroughly rinsed with fresh

water and dried with a soft towel after each dive. Make sure that all salt crystals and sand

particles have been flushed out. Check the display for possible moisture or water, and do

not use the Suunto Cobra2 if you detect any moisture or water inside.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 55 56

Comments to this Manuals

No comments

Suunto Cobra2 User Manual Page 40

Comments to this Manuals

Related products and manuals for Computers Suunto Cobra2