Suunto Cobra2 User Manual download pdf (Page 13)

AC APPEARS IN THE TOP RIGHT

CORNER OF THE DISPLAY, WHEN THE DIVE

COMPUTER IS IN CONTACT WITH WATER.

THIS ALSO ACTIVATES THE DIVE MODE.

Contamination or dirt on the water contact may prevent this automatic activation. It is

therefore important that the water contact is kept clean. The contact can be cleaned with

fresh water and a soft brush, for example a tooth brush.

4.3. Learning how to use your compass

Suunto Cobra2 integrates a digital compass, which can be used both while diving and on

dry land, and can be accessed from either the DIVE mode or TIME mode.

IF ACCESSED FROM TIME MODE,

TIME AND BEARING ARE DISPLAYED AT

THE BOTTOM OF THE SCREEN.

IF ACCESSED FROM DIVE MODE,

CURRENT DEPTH AND TIME OR

MAXIMUM DEPTH, AS WELL AS BEARING

OR DIVE TIME OR TEMPERATURE ARE

DISPLAYED.

NOTE

When accessed from DIVE mode, toggle between the alternative

displays by pressing the UP/DOWN buttons.

NOTE

In order to save battery power, the compass display will automatically

return to the TIME or DIVE mode 60 seconds after the last button-

press.

4.3.1. Compass display

The Suunto Cobra2 displays the compass as a graphical representation of a compass

rose. The rose displays the cardinal and half cardinal points, in addition to which, the

current bearing is also displayed numerically.

Tilt sensor

The compass has a tilt sensor, so it doesn't have to be completely level in order to display

the correct bearing. As long as the device is held at an angle of +/- 5

to level, the compass

will display the correct bearing. If the device is not held within this range, no bearing will

be displayed.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

No comments

Suunto Cobra2 User Manual Page 13