Suunto Cobra2 User Manual download pdf (Page 21)

5.8.5. Setting the sample rate

The sample rate controls how often the depth, time, tank pressure, and water temperature

is stored in the memory. You can set the dive profile sample rate to 1, 10, 20, 30, or 60

seconds. The factory default setting is 20 seconds.

ADJUST WITH UP AND

DOWN BUTTONS. ACCEPT

WITH SELECT BUTTON.

5.8.6. Setting the Safety Stops/Deep Stops

The Deep Stop setting allows you to choose between traditional Safety Stops or Deep

Stops. If Deep Stops are set to OFF, only the traditional Safety Stop calculation is used.

If set to ON, iterative Deep Stops will be prompted aswell. The length of the individual

Deep Stops can be set to 1 or 2 minutes.

ADJUST WITH UP AND

DOWN BUTTONS. ACCEPT

WITH SELECT BUTTON.

5.8.7. Setting the RGBM values

For certain divers and diving conditions, it may be desirable to set the attenuated RGBM

mode. The selection is displayed during the DIVE mode startup. The options are full RGBM

effects (100%), and attenuated RGBM (50%).

ADJUST WITH UP AND

DOWN BUTTONS. ACCEPT

WITH SELECT BUTTON.

5.9. Activation and pre-checks

This section describes how to activate the DIVE mode and explains the pre-checks that

it is highly recommended you perform before you get into the water.

5.9.1. Accessing DIVE mode

The Suunto Cobra2 has three diving modes: AIR mode for diving with standard air only,

NITROX mode for diving with oxygen enriched mixtures, and GAUGE mode for use as a

bottom timer. The OFF mode disables the DIVE mode, and allows the TIME mode to be

used underwater. The chosen dive mode is displayed when the DIVE mode is accessed,

and you can toggle between the submodes by pressing the UP/DOWN buttons.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

No comments

Suunto Cobra2 User Manual Page 21