Suunto OCTOPUS II User Manual download pdf (Page 51)

NOTE: In case of the minutes and date, the change is made separately for both digits,

as shown by the blinking digit. In case of the hours and month, the complete number is

changed simultaneously.

4. Repeat steps 2 and 3 to change any additional values.

5. Exit the Time Setting mode with the RETURN command, i.e. by connecting

all three

contacts at the same time. First make contact between the PLAN/ON and TIME/MODE

contacts and after that with the COM contact.

NOTE: The clock is on (time is elapsing) when setting it and exiting the Time Setting

mode. It is not possible to reset the seconds.

Remember to regularly check that the clock is on time especially when traveling to

different time zones, as the entry time of all dives is stored in the logbook memory.

Fig. 4.14 TIME SETTING

Scrolling through hours, minutes, month

and date, TIME/MODE & COM.

Fig. 4.15 TIME SETTING

Adjusting the ten minute reading (blinking),

PLAN/ON & COM.

COM

TIME

MODE

PLAN

LOG HIS ALT SET PLAN

COM

TIME

MODE

PLAN

LOG HIS ALT SET PLAN

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 65 66

No comments

Suunto OCTOPUS II User Manual Page 51