Suunto BIKE POD User Manual download pdf (Page 6)

6. Attach the holder for your Suunto wristop computer to the handle bar with the

flat part facing up. Place the Suunto t-series wristop computer around it. (See

the figure under point 5 in section 3.1.3.)

3.2.3. INSTALLING THE MAGNET MOUNT

Position the magnet mount on a spoke so that it passes in front of one of the

marks on the lever. The magnet must be turned towards the Bike POD.

• Hub (1)

• Magnet (2)

•Bike POD (3)

3.3. ACTIVATION AND DEACTIVATION

Your Bike POD is activated automatically when the spoke magnet passes the

Bike POD, i.e. when the front wheel spins. It stays active throughout the cycling

trip and for half an hour after the Bike POD has stopped receiving readings from

the magnet.

3.4. CONNECTION

To use your Bike POD, you must establish a connection between it and your

wristop computer. This can be compared to listening to a radio. To be able to

receive the radio broadcast signal, you need to switch the radio on. Similarly, for

your wristop computer to be able to receive the signal from your Bike POD, the

devices must be connected. You need to establish the connection every time

you want to use your wristop computer with your Bike POD.

1. Spin the front wheel so that the spoke magnet passes the Bike POD.

2. In your Suunto t6, select Connect in the Speed/Distance menu.

In your Suunto t3 or Suunto t4, enter Training mode.

3. Your wristop computer informs you when the Bike POD has been found.

Suunto t3 or Suunto t4: If the connection fails, the message “Searching”

disappears from the bottom row of the display and the selected shortcut returns.

In this case, spin the front wheel again to ensure that the Bike POD is active and

try again.

Suunto t6: If the connection fails,”NO DEVICES FOUND” is displayed on the

screen. In this case, spin the front wheel again to ensure that the Bike POD is

active and try again.

+/- 45 o

1 2 3 4 5 6 7 8 9 10 11

No comments

Suunto BIKE POD User Manual Page 6