Suunto Regatta User's Guide download pdf (Page 13)

CHAPTER 2 SAILING TIMER MODE

To view Sailing Timer:

Check the Mode Indicator Bar. If the mode arrow is not on SAIL, PRESS the [Mode] button until the arrow is directly below

SAIL on the bar.

In the Sail mode (Fig. 2.):

• Field 1 the selected time to be counted down in minutes, maximum 120 minutes;

• Field 2 the time to be counted down in minutes and seconds; and

• Field 3 the current time and the text “log book” to the left of the current time.

To set the count down, PRESS the [-] button, the selection will begin with 120 minutes. It is adjustable in 10-minute

increments, from 120 to 60 minutes, in 5-minute increments, from 60 to 15 minutes, and from 15 minutes to 0 by the minute.

Continue pressing the [-] button until the desired minute is achieved. The selected time is stored in Field 1.

To begin the countdown, PRESS the [+] button. [-] will start the timer again from the preset minute.

During the count down the timer will activate audible signals.

Interval Audible signal

Every full minute Short double beep

Every 10 seconds during the last minute Short double beep

Every second during the last ten seconds Short single beep

At the completion of the count down Long single beep

When the time to count down has been reached, a stopwatch will automatically start running (Fig. 3). The range of the

stopwatch is 120: 00,00.

• Field 1 displays the seconds and tenths of seconds of the event;

• Field 2 displays the hours and minutes of the event; and

• Field 3 displays the current time and the text “logbook” to the left of the current time.

During this activity when the stopwatch is running, the [-] button can be used to store up to 50 split times (way point times)

to be viewed after the race has been completed. The split time (way point time) will be displayed for 10 seconds after

pushing the [-] button.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 269 270

No comments

Suunto Regatta User's Guide Page 13